11 34 560 Replacing all valve stem seals (N52K)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Firmly press special tool 11 1 480 onto old valve stem seals.

Detach valve stem seal from valve stem by turning and simultaneously pulling special tool 11 1 480.

Installation:

Insert all VALVES .

Fig 1: Inserting Valves Using Special Tool (11 1 480)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For use on the N52K engine, special tool 11 6 380 must be remachined according to the picture with a 10 mm dia. drill bit to a depth of B = approx. 23 mm.
This modification has already been taken into account for reordering.

Fig 2: Identifying Drilling Depth On Special Tool (11 6 380)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Different diameters at valve stem.
All valve stem seals are colour-coded.

For 5 mm dia. valves, the valve stem seal is marked red or brown.

For 6 mm dia. valves, the valve stem seal is marked green or light green.

Fig 3: Identifying Valve Stem Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit the mounting sleeves (plastic sleeves) contained in the delivery specification on the valve stem end.

Lubricate mounting sleeve.

Press on valve stem seal by hand with special tool 11 6 380 as far as it will go.

Fig 4: Pressing Valve Stem Seal Using Special Tool (11 6 380)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.