11 37 005 Removing and installing/replacing eccentric shaft (N52K)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Remove CYLINDER HEAD COVER
Remove INTERMEDIATE LEVER

If necessary, move eccentric shaft (1) on twin surface to minimum lift (2).

Fig 1: Moving Eccentric Shaft On Twin Surface Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: All bearing caps (1 and 2) of eccentric shaft are marked with numbers from 1 to 6 (1 for 1st cylinder to 6 for 6th cylinder).
Bearing cap 6 (1) is provided with a stop.

Release screws on bearing cap 6 (1).

Release screws on bearing caps 1 to 5 (2).

Set all bearing caps down in special tool 11 4 481 in a neat and orderly fashion.

Remove eccentric shaft with gentle tilting and turning movements.

Fig 2: Installing Bearing Cap On Bearing Cap Number

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Screw is not magnetic and must be secured against falling down.

Release screw.

Remove magnet wheel (1).

Fig 3: Locating Magnet Wheel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Magnet wheel (1) is highly magnetic and must be protected against metal filings/borings.
After removing, place magnet wheel (1) in a plastic bag (2) with a seal.

Fig 4: Identifying Magnet Wheel In Plastic Bag

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Needle bearing (1) can break very easily.

Carefully pull needle bearing (1) apart at point of separation.

Remove all needle bearings (1) from eccentric shaft.

Fig 5: Removing Needle Bearing

Courtesy of BMW OF NORTH AMERICA, INC.

Install bearing shells (1) as pictured.

NOTE: Always replace bearing shells (1) and needle bearings together.

Fig 6: Locating Bearing Shells Ends

Courtesy of BMW OF NORTH AMERICA, INC.

Install bearing shell (1) with tip facing down (see arrow) in cylinder head.

Install bearing shell (2) with tip facing up in bearing cap.

Fig 7: Locating Bearing Shell Tip

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: All bearing caps (1 and 2) of eccentric shaft are marked with numbers from 1 to 6 (1 for 1st cylinder to 6 for 6th cylinder).
Bearing cap 6 (1) is provided with a stop.

Insert eccentric shaft.

Adjust eccentric shaft on dihedron to minimum stroke.

Fit all bearing caps (1 and 2).

Insert all screws.

Fig 8: Installing Bearing Cap On Bearing Cap Number

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 11 12 7AZ .

Installation:

Spline teeth of eccentric shaft must be greased with LONGTIME PD 1 (2.2) .

Assemble engine.