Condition for fault identification

Test condition:

The fault is recognized when the speed signal is 0 km/h although other operating conditions indicate that the vehicle is moving.

Potential problem source(s):

L4 Wheelspeed sensor at left front, wire or EHB3 is defective

L6 FlexRay bus fault, ICMQL, DSC, wheelspeed sensors

Terminal condition: none

Voltage condition:

• Electrical system voltage > 10 V

Temperature condition:

• None

Time condition:

• None

Other conditions:

• E7X: Mass airflow > 272 mg/stroke; engine speed > 2820 RPM
• F01: Drive torque > 46 Nm; engine speed > 1450 RPM