Condition for fault identification

Test condition:

The fault is recognized when a required throttle valve adaptation cannot be implemented due to failure to comply with specified general environmental conditions.

Potential problem source(s):

• Failure to comply with specified conditions when throttle valve adaptation routine is activated (electrical system voltage > 10V, Terminal 15 on, engine off, no other throttle valve diagnostic fault codes logged)
• Convenience start after programming or replacing the DME

Terminal condition: Terminal 15

Voltage condition:

• Electrical system voltage > 10 V

Temperature condition:

• Intake air temperature > -10 °C
• Coolant temperature > -10 °C
• Coolant temperature < 142 °C

Time condition:

• 5 sec.

Other conditions:

• Engine off
• No other throttle valve diagnostic fault codes logged in control module fault memory