22 11 011 Replacing left engine mount (N54)

Necessary preliminary tasks: 

• Secure engine in INSTALLATION POSITION
• Remove REAR UNDERBODY PROTECTION
• Release ENGINE SUPPORT ARM 

Release screws (1) and remove engine mount.

Tightening torque 22 11 1AZ .

Fig 1: Identifying Engine Mount Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Rubber section (1) of engine mount must point to middle of vehicle.

Fig 2: Identifying Rubber Section Of Engine Mount

Courtesy of BMW OF NORTH AMERICA, INC.