12 61 280 Removing and installing/replacing oil pressure sensor (N54)

Necessary preliminary tasks:

WARNING: Scalding hazard!
Only perform this task on an engine that has cooled down.

Installation location:

Oil filter housing, front left.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Unlock plug (1) and remove.

Release oil pressure sensor (2).

Tightening torque 12 61 1AZ .

Fig 1: Identifying Oil Pressure Sensor And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Add final details to vehicle

Check engine oil level. Top up engine oil if necessary.