84 10 050 Removing and installing (replacing) USB hub

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks

Remove LEFT FRONT SEAT .
Remove FRONT LEFT ENTRANCE COVER STRIP .
Fold back carpet for passenger compartment at front left in direction of travel.

Remove USB hub protective socket (1) from footwell insert (2).

Unlock catches (3) with a suitable tool and remove USB hub protective socket cover (5).

Installation:

Make sure USB hub protective socket cover (5) engages correctly on USB hub protective socket lower section.

Seal (4) must not be damaged; if necessary, replace USB hub protective socket cover (5).

Fig 1: Identifying Catches, USB Hub Protective Socket Cover And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Remove USB hub (1) from USB hub protective socket lower section (2).

Installation:

Make sure rubber grommet (4) is correctly seated on USB hub protective socket lower section (2).

Disconnect plug connection (3).

Fig 2: Identifying USB Hub, Rubber Grommet And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.