52 24 311 Removing and installing/replacing lock for left or right rear seat backrest

Unfasten screws (2).

Tightening torque 52 24 02AZ .

Fig 1: Identifying Rear Seat Backrest With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

REMOVE  backrest and set down forwards.

Remove lock (1) completely from installation opening.

Fig 2: Removing Backrest And Set Down Forwards

Courtesy of BMW OF NORTH AMERICA, INC.

Display bridge (1) can be pressed out of lock during emergency actuation.

Remove display bridge (1) from lock.

Display bridge (1) does not have to be reinstalled.

Fig 3: Identifying Display Bridge On Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Slide guide lug (1) of lock into opening (2).

Fig 4: Sliding Guide Lug Of Lock Into Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock: 

• Slacken screws
• Firmly push engaged backrest back
• Tighten down screws