51 13 280 Removing and installing/replacing trim strip on roof frame at left or right

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary work:

E84 and E91 only:

Lever out trim strip (1) with special tool 00 9 321 starting at rear.

Unclip trim strip (1) in direction of arrow.

Fig 1: Unclipping Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Clips (1) and seals (2) on trim strip (3) must not be damaged.

If necessary, replace faulty clips (1).

Position of clips (1) on trim strip (3) is determined by notch (4).

Fig 2: Identifying Clips And Seals On Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Push trim strip (1) at front into seal (2).

Trim strip (1) must be flush with edge (3) at rear.

Fig 3: Pushing Trim Strip At Front Into Seal

Courtesy of BMW OF NORTH AMERICA, INC.