51 13 116 Removing and installing cowl panel cover: Notes

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

IMPORTANT: Danger of water ingress via fan into vehicle interior if cowl panel cover and sealing strip are not correctly fitted.

Pull off hose (1).

Disconnect plug connections (2).

Detach mucket (3).

Take off cover (4).

Installation:

Make sure cover (4) is correctly seated.

Fig 1: Identifying Detach Mucket, Plug Connections, Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Sealing strip (1) must be fitted (water ingress)

If necessary, retrofit sealing strip (1).

Fig 2: Identifying Retrofit Sealing Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure grommets (1) are correctly seated on wiper pivots.

Grommets (1) for wiper pivots must not be damaged.

If necessary, replace grommets (1).

Fig 3: Identifying Grommets For Wiper Pivots

Courtesy of BMW OF NORTH AMERICA, INC.