51 43 201 Removing and installing or replacing trim for roof pillar at front (A-pillar), left or right

WARNING: This page is about a different variant/trim than selected.

Special tools required:

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Unclip protective cap (1) with special tool 00 9 341 and remove.

Fig 1: Identifying Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Release mucket (1) in area of trim for front roof pillar (2).

Release screw (3), tightening torque 51 43 1AZ .

Unclip trim for front roof pillar (2) from mounting point (4).

Feed trim for front roof pillar (2) out of instrument panel trim (5) and remove.

Fig 2: Releasing Mucket In Area Of Trim For Front Roof Pillar

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clip (1).

Make sure guides (3) of trim for front roof pillar (2) are correctly seated in associated mountings.

Position trim for front roof pillar (2) preassembled with clip (1) on associated bore and clip into place.

Fig 3: Identifying Front Roof Pillar, Faulty Clip And Guides

Courtesy of BMW OF NORTH AMERICA, INC.