51 49 000 Removing and installing/replacing panel for rear lid

WARNING: This page is about a different variant/trim than selected.

Version with emergency release:

Detach handle (1) from clip (2).

Disconnect Bowden cable (3) from handle (1).

Installation:

Guide Bowden cable (3) through clip (2) and connect correctly in handle (1).

Fig 1: Identifying Bowden Cable From Handle And Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release clips (1) and remove panel (2).

Installation:

If necessary, replace damaged clips (1).

Fig 2: Identifying Panel With Clips

Courtesy of BMW OF NORTH AMERICA, INC.