51 45... Removing and installing carrier for instrument panel

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Remove INSTRUMENT PANEL TRIM
Disconnect all necessary cable ties on support tube
Release wiring harnesses/cable ducts and lay to one side
If necessary, remove control units/disconnect plug connections

WARNING: To avoid injury, cover holder (1) on support tube (2).

Fig 1: Identifying Cover Holder And Support Tube

G04727790

Courtesy of BMW OF NORTH AMERICA, INC.

Detach wiring harness (3) from support tube (2).

Release screws (1) of heater on support tube (2).

Tightening torque 64 11 6AZ .

Fig 2: Identifying Wiring Harness Support Tube And Screws

G04727798

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) on right and left on support tube (2).

Tightening torque 51 71 5AZ .

Fig 3: Identifying Support Tube And Nuts

G04727799

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) of heater on support tube (2).

Tightening torque 51 71 6AZ .

Fig 4: Identifying Support Tube And Screw

G04727797

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on support tube (2).

Tightening torque 51 71 5AZ .

Fig 5: Identifying Screw And Support Tube

G04727801

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on support tube (2) from bracket (3).

Tightening torque 51 71 4AZ .

Detach support tube (2) with a 2nd person helping and remove.

Fig 6: Identifying Support And Tube Screws

G04727802

Courtesy of BMW OF NORTH AMERICA, INC.