4. Bonding
WARNING: This page is about a different variant/trim than selected.
- 4.1 Components without preassembled adhesive tape
- Pull off liner* from adhesive tape
- Position adhesive tape on component and stick on
- Press down adhesive tape over entire adhesive area
- Continue with Point 4.2
* Liner is the protective film on the adhesive tape.
- 4.2 Components with pre-fitted adhesive tape
- Pull off liner* from adhesive side (if adhesive area is large, do not pull off liner completely)
- Align component in correct position on vehicle
- Press down component over entire adhesive area
Minimum contact pressure ≥ 15 N/cm2 (firm thumb pressure reaches approx. 35 N/cm2 .)
* Liner is the protective film on the adhesive tape.