Positioning aid "C1" for rear door, left ("D1" right)
WARNING: This page is about a different variant/trim than selected.
Detach prestamped positioning aid from backing.
- Positioning aid "C1" rear door, left (below positioning aid "C2")
- Positioning aid "D1" rear door, right (below positioning aid "D2")
If necessary, cut out prestamped cut-out for bore hole from positioning aid. Align positioning aid with printed mark (X), contact edge (2 and 3) to rear door and positioning aid "C2" or "D2" and press on.
Seal must rest on positioning aid (1) during bonding.
X Start of bending radius