LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 335i 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Body Equipment - Repair - E90) >> Front Bumper >> 51 11... Installing/replacing number/license plate (without base) >> Initial fitting

Initial fitting

WARNING: This page is about a different variant/trim than selected.

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to car registration number plate specifications.

Remove template (1) and secure car registration number plate with screws provided.

Fig 1: Placing Drilling Hole Template On Bumper
G04752434Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 51 11 3AZ .

Fit protective caps.

Place drilling hole template (1) on radiator grille (2) and bumper (3).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to car registration number plate specifications.

Remove template (1) and secure car registration number plate with screws provided.

Tightening torque 51 11 3AZ .

Fit protective caps.

Fig 2: Securing Car Registration Number Plate With Screws Provided
G04752435Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals