Pulling cutting wire into vehicle

WARNING: This page is about a different variant/trim than selected.

Grip wire with pliers
(If access is difficult: using wire starter 2 150 267, feed wire through adhesive bead.)
Wire end (1) must be bent towards window glass.
Heat wire end (1) and use it to pierce adhesive bead (2).
Pull approximately half of the wire into the passenger compartment

Fig 1: Identifying Wire End And Pierce Adhesive Bead
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: When using the separating cord, always pull it in using the wire starter 2 150 267.