Feeding in the cord on the separation device
WARNING: This page is about a different variant/trim than selected.
Normally, the adhesive bead is cut through counter-clockwise seen from the passenger compartment.
- This means the cord must be fed into the separation device as shown in graphic A.
When accessibility is not optimal, the opposite cutting direction may be required (comply with vehicle-specific repair instructions).
- This means the cord must be fed into the separation device as shown in graphic B.
Feed cord into coil and wind it on, at the same time trapping the end of the cord.
When winding the cord, the correct direction of rotation on the separation device must be observed.