3.3 Remove adhesive residue from the body and window glass
WARNING: This page is about a different variant/trim than selected.
Do not remove residual adhesive bead (1) until shortly before bonding.
Use the pitchweld scraper to remove the residual adhesive bead (1) from the body aperture and window glass (3).
Position the pinchweld scraper (2) as shown and remove the residual adhesive bead (1) up to a thickness of approx. 0.5 mm.
Attention!
Carbon body components are not to have scratches with a depth greater than 0.2 mm.
Note, comply with life module check!