51 31 025 Replacing left or right gutter strip along windscreen

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

NOTE: To facilitate installation, coat seal and gutter strip with water.

Fit inner part (1) of seal in accordance with measurements (A and B) on gutter strip (2).

A= approx. 30 mm

B= approx. 15 mm

Push seal (1) onto gutter strip (2) until both are flush in area (3).

Fig 1: Identifying Push Seal, Gutter Strip And Flush Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Outer part (2) and inner part (3) of seal must not be stretched.

Fit outer part (2) and inner part (3) of seal on complete gutter strip (1).

If necessary, use special tool 00 9 323 as an aid.

Fig 2: Identifying Gutter Strip, Outer Part And Inner Part Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Align seal (1) to gutter strip (2) and secure in area (3) with Loctite 380 (sourcing reference: BMW Parts Service).

A= Gutter strip, top

B= Gutter strip, bottom

Fig 3: Identifying Gutter Strip Top And Bottom

Courtesy of BMW OF NORTH AMERICA, INC.