Replacement of rubber frame without windscreen removal
WARNING: This page is about a different variant/trim than selected.
There is no sealing lip (2) in area (A) on left/right.
Detach tear-off lip (4) from rubber frame (1).
If adhesive leaks over tear-off lip (4), this area must be cut out partially.
To facilitate installation, coat rubber frame (1) and body cutout with water.
Install rubber frame (1).
If necessary, pull liner* off adhesive tape (6) and press rubber frame (1) down firmly on roof outer skin.
3 Butylene tape
5 Aluminium strip
* Liner is the protective film on adhesive tape (6).