Field of vision (no repairs acceptable)
WARNING: This page is about a different variant/trim than selected.
- 50 mm (gap between field of view/center of vehicle)
- Up to end of wiper range, outside (field of view width)
- Restriction by wiper range (height of field of view)
IMPORTANT:
- Repairs must only be carried out outside of the field of vision (refer to Fig 1).
- Only damage to the outer surface of the windscreen may be repaired.
- The inner window pane and the plastic film between inner and outer window panes must not be damaged.
- Repairing should be carried out as soon as possible after occurrence of the damage.
- The penetration of moisture or dirt must not be visible in the damaged spot.
- Impact spot cavities must not exceed a diameter of 5 mm.
- Cracks leading away from the impact spot must not be longer than 50 mm.
- Cracks must not end in the rubber window frame or decorative strip.
- Visibility through the repaired surface must be clear, transparent and with minimum distortion.
- Cover engine hood and front side walls with protective covers.
- Note processing instructions!