51 14... Instructions for attaching number/letter designation combination: Assembly

WARNING: This page is about a different variant/trim than selected.

Number and letter combinations (1) of the model designation are not connected to each other and are supplied on a carrier film (2).

IMPORTANT: Adhesive areas must be dry and free of dust and grease.
Once it has been cleaned, do not touch the adhesive area with bare hands.

Fig 1: Identifying Model Designation On Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Remove liner (3) (protective strip for adhesive surface).

Firmly press down model designation. Remove carrier film (2).