51 14 110 Removing and installing/replacing rear model designation\n (brilliance)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
The "INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING " serve as the basis for these repair instructions and must be followed without fail.
Apply the adhesive tape (1) between the edge of the tailgate (3) and the upper edge of dimension "A".
Mark dimension "B" from the outer edge of the tailgate on the adhesive tape (1) and apply the adhesive tape (2) vertically.
E60 dimensions:
A = 18 mm
B = 38 mm
E90 dimensions:
A = 25 mm
B = 46 mm
Pull of the liner (safety strip for bonding surface).
Fit the lettering on the adhesive tapes (1 and 2) and apply them.