51 14 000 Removing and installing/replacing front BMW badge

WARNING: This page is about a different variant/trim than selected.

Special tools required:

IMPORTANT: Risk of damage!

To avoid damaging the paintwork on the engine hood/bonnet, tape off edge areas (1) to sides of guide pins.

So as not to subject the BMW badge to excessive deformation, lever out the badge with special tool 00 9 325 at guide pins (2).

Fig 1: Levering Out Badge With Special Tool 00 9 325 At Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

The following parts must not be damaged or missing, replace if necessary:

Adhesive tape (4)

Fig 2: Identifying Badge, Guide Pins, Grommets And Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.