34 52 550 Removing and installing/replacing DSC sensor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Lift carpet (1) and fold back to side.

Remove underlay (2).

Disconnect plug connection.

Installation:

Ensure proper locking of plug connector.

Slacken screws (3)

Release screws (4) and remove bracket with yaw sensor.

Installation:

Tightening torque 34 51 3AZ .

Fig 1: Identifying Yaw Sensor Screw And Carpet

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing DSC sensor:

Release screws (1) and modify DSC sensor (2).

Installation:

Tightening torque 34 51 2AZ .

Fig 2: Identifying DSC Sensor Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out calibration/adjustment of DSC sensor.