72 11 098 Removing and installing/replacing all rear lower belt fittings
WARNING: This page is about a different variant/trim than selected.
WARNING:
Read and comply with SAFETY REGULATIONS
for handling airbag modules and pyrotechnical belt tensioners.
Necessary preliminary tasks:
- Remove rear seat. See REAR SEAT or REAR SEAT (THROUGH-LOADING)
Illustration show removal of the left lower belt fitting; proceed in the same way for the right fitting.
Release screw (1).
Tightening torque 72 11 23AZ .
Remove lower belt fitting (2).
Installation:
Pin (3) determines the installation position and prevents the lower belt fitting (2) from turning.
NOTE:
Middle lower belt fitting (4) can only be removed in conjunction with right lower belt fitting.
Lower belt fitting with belt tensioner:
Illustration show removal of the left lower belt fitting; proceed in the same way for the right fitting.
Unfasten PLUG CONNECTION (2) and disconnect.
Release screw (1).
Tightening torque 72 11 23AZ .
Remove lower belt fitting (3).
Installation:
Pin (4) determines the installation position and prevents the lower belt fitting (3) from turning.
NOTE:
Middle lower belt fitting (5) can only be removed in conjunction with right lower belt fitting.