61 35 107 Removing and installing or replacing Junction Box electronics

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

NOTE: Glovebox removed for purposes of clarity.

Disconnect plug connection (1).

Release screws (2) and remove junction box electronics (3) from holder.

Fig 1: Removing Junction Box Electronics From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Installation:

Make sure junction box electronics is correctly seated on plug connection (2) of holder.

Fig 2: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Delete transport mode.