65 11 080 Removing and installing/replacing radio
NOTE:
Comply with notes and instructions on HANDLING OPTICAL FIBRES
.
Necessary preliminary tasks:
- Clamp off BATTERY NEGATIVE LEAD .
- Remove CONTROL PANEL FOR HEATING AND A/C SYSTEM .
Release screws (1).
Pull back radio (2) slightly.
Disconnect associated plug connections and remove radio (2).
Installation:
Make sure the rear guide pin of the radio (2) is correctly seated in the associated mounting.
US version only:
If there is a violet aerial connection (1) as well as the black aerial connection (2), additional tasks are required when replacing the radio!
See REPLACING SATELLITE TUNER .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .