64 11 377 Removing and installing or replacing heater/air conditioner operator unit (version without CCC/ASK)

Special tools required:

00 9 340

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

NOTE: C ar C ommunication C omputer (CCC)
A udio S ystem K ontroller/Controller (ASK)

Insert special tool 00 9 340 as illustrated and unclip lower area of control panel trim (1).

Fig 1: Identifying Special Tool (00 9 340)

G06177894

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 00 9 340 as illustrated and unclip side section of control panel (1).

Detach control panel (1) and disconnect plug connections.

Fig 2: Identifying Special Tool (00 9 340)

G06177895

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure retaining clips (1) are fitted correctly.

If necessary, replace missing clips.

Fig 3: Identifying Control Panel Retaining Clips

G06177896

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The center console switch cluster (1) and the heater/air conditioner operator unit (2) are connected via the ribbon cable (4).

Fig 4: Identifying Center Console Switch Cluster And Heater/Air Conditioner Operator Unit

G06177897

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

IMPORTANT: Risk of damage to operator unit (3)!

Carefully unclip operator unit trim (1) at inner retaining points (2) only.

Fig 5: Identifying Operator Unit Trim And Retaining Points

G04727815

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip operator unit trim (2) at outer retaining points (2) only.

Remove trim (1) from operator unit (3).

Fig 6: Identifying Operator Unit And Trim

G04727816

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out PROGRAMMING/CODING .