63 12 870 Replacing ignition unit for left xenon headlight (with xenon bulb) (from 03/2007)

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by qualified personnel.
Follow instructions for handling light bulbs (EXTERIOR LIGHTS) .

IMPORTANT: Ignition unit and xenon bulb are viewed as a single component and must not be separated.

N52K:

Necessary preliminary work:

Remove intake silencer housing

Unlock spring wire clips (1) in direction of arrow.

Remove cover (2) in upward direction from headlight (3).

Installation note:

Make sure cover (2) is correctly seated on headlight (3).

Fig 1: Removing Spring Wire Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock turning ring (2) in counterclockwise direction.

Detach ignition unit (3) towards rear from headlight (4).

Installation note:

Make sure ignition unit (3) is exactly seated in headlight (4).

Fig 2: Identifying Plug Connection, Turning Ring, Ignition Unit & Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Recommendation:

Check HEADLIGHT ADJUSTMENT , correct if necessary.