13 71 000 Removing and installing/replacing the intake silencer housing (N54T)

For E60/E61 the repair work is described in:

Removing and installing/replacing intake silencer housing

Necessary preliminary tasks:

Unclip B+ cable strip (1).

Fig 1: Identifying B+ Cable Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Illustration shows microfilter housing removed for purposes of clarity.

Pull wiring harness mounting (1) up.

Fig 2: Identifying Wiring Harness Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp (1) and detach air intake hose.

Tightening torque 13 71 2AZ .

Fig 3: Identifying Air Intake Hose Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp and detach air intake hose.

Tightening torque 13 71 1AZ .

Unlock and disconnect line (1).

Unclip line (1) from air filter housing.

Fig 4: Identifying Line From Air Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Slightly raise front of intake silencer housing (1) in direction of arrow.

Press rear of intake silencer housing upwards out of mounting points and remove.

Fig 5: Lifting Front Of Intake Silencer Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Push rear area of intake silencer housing (1) under B+ cable strip (2) and guide (3).

While doing so, push guide (3) up a little.

Fig 6: Identifying Intake Silencer Housing Rear Area Under B+ Cable Strip And Guide

Courtesy of BMW OF NORTH AMERICA, INC.