23 42 542 Replacing Shift And/Or Selector Sensor GS6S53BZ (SMG)

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

After completing work:

Perform "Teach in transmission" service function by means of DIS Tester

Necessary preliminary tasks:

Remove SMG TRANSMISSION

IMPORTANT:

Shift and selector sensors can only be removed/installed when transmission is set to "N".

Removing shift sensor:

Unfasten screws.

Tightening torque 23 41 11AZ . See EXTERNAL GEARSHIFT COMPONENTS for specs.

Turn shift sensor (1) approx. 90° clockwise.

Installation:

Replace screws.

Fig 1: Locating Shift Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out shift sensor (1) upwards at an angle.

Unclip cable.

Fig 2: Removing Shift Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit shift sensor (1) downwards at an angle and turn counterclockwise until installation position is reached.

IMPORTANT:

Risk of damage:

When fitting shift sensor (1), make sure that lever (2) engages in groove (3) on selector rod.

Fig 3: Identifying Shift Sensor Installation Position

Courtesy of BMW OF NORTH AMERICA, INC.

Removing selector sensor:

Unfasten screws.

Tightening torque 23 41 11AZ . See EXTERNAL GEARSHIFT COMPONENTS for specs.

Turn selector sensor (1) counterclockwise slightly.

Installation:

Replace screws.

Fig 4: Turning Selector Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out selector sensor (1) upwards at an angle.

Unclip cable.

Fig 5: Removing Selector Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit selector sensor (1) downwards at an angle and turn clockwise until installation position is reached.

Fig 6: Identifying Shift Sensor Installation Position

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

After completing work:

Perform "Teach in transmission" service function by means of DIS Tester