11 22 000 Removing And Installing/Replacing Flywheel (N62/N62TU)
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 11 4 180
- 11 9 260
- 11 9 262
- 11 9 263
- 11 9 264
Necessary preliminary tasks:
- Remove automatic transmission. See REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (6HP26Z/N62) or REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (6HP26Z/N62TU) FROM 03/07 .
- Remove manual transmission. See REMOVING AND INSTALLING TRANSMISSION (GS6-53BZ) or REMOVING AND INSTALLING TRANSMISSION (GS6S53BZ SMG) .
- Remove CLUTCH .
Automatic transmissions only:
Block flywheel (1) with special tools 11 9 260 / 11 9 263 / 11 9 264.
Unfasten flywheel screws.
Remove flywheel (1).
Installation:
Clean threads on flywheel screws in crankshaft.
Flywheel (1) is secured with an alignment pin.
Fit flywheel (1).
Fit new flywheel screws.
Tightening torque: 11 22 1AZ . See FLYWHEEL for specs.
Manual transmissions only:
Block flywheel (dual-mass) with special tools 11 9 260 / 11 9 262 / 11 9 263.
Release flywheel screws with special tool 11 4 180.
Installation:
Flywheel (1) is secured with an alignment pin.
IMPORTANT:
Do not use screw locking varnish .
Tightening torque: 11 22 1AZ . See FLYWHEEL for specs.