32 00 150 KDS Chassis/Wheel Alignment Check With Load Up To Design Position

IMPORTANT: Carry out chassis/wheel alignment with DIN load only:

If the technical preconditions for alignment with ride height input are not in place
If, in spite of repairs having been carried out, the car's ride height between the left and right sides is still outside the tolerance
If the vehicles in question have been involved in an accident

NOTE: Calibrate reversing camera after chassis/wheel alignment. See 66 53 010 CALIBRATING REVERSING CAMERA .

NOTE:

Read and comply with General information and definitions . See 32 00... GENERAL INFORMATION AND DEFINITIONS .
Read and comply with General chassis definition . See 32 00... GENERAL CHASSIS AND SUSPENSION DEFINITIONS .

If necessary, prepare lifting platform.
Drive vehicle onto lifting platform.
NOTE: The front and rear wheels must be positioned centrally on the rotary and sliding plates.
Remove locking pins from both rotary and sliding plates.

Fig 1: Identifying Rotary And Sliding Plates
Courtesy of BMW OF NORTH AMERICA, INC.
Attach quick-clamping holder/quick-clamping unit to vehicle and remove clamping levers in area of front wheels
Attach pickup to quick-clamping holder/quick-clamping unit, align using bubble level and connect to rotary plates
NOTE: When using quick-clamping units, perform RIM RUNOUT COMPENSATION after installing the pickups.

Fig 2: Attaching Quick-Clamping Holder/Quick-Clamping Unit To Front Wheel
Courtesy of BMW OF NORTH AMERICA, INC.
If necessary, attach spoiler adapter.

Fig 3: Identifying Spoiler Adapter
Courtesy of BMW OF NORTH AMERICA, INC.
Enter customer and vehicle data
Identify chassis version and select vehicle. See 32 00... IDENTIFICATION OF SUSPENSION WITHOUT LABEL .
Enter tire pressure and tread depth
Move vehicle into design position . See 32 00... MOVING VEHICLE INTO DESIGN POSITION .
Install brake tensioner.

Fig 4: Locating Brake Tensioner
Courtesy of BMW OF NORTH AMERICA, INC.
Perform input measurement in accordance with equipment manufacturer's instructions.
Compare specified values with actual values. See STEERING AND WHEEL ALIGNMENT - TECHNICAL DATA .
If necessary, adjust front axle and rear axle . See 32 00 620 ADJUSTING REAR AXLE .
Perform output measurement in accordance with equipment manufacturer's instructions.
Save and print out test record.
Carry out steering angle sensor adjustment/adjustment for active front steering . See 32 10 005 ADJUSTMENT FOR ACTIVE FRONT STEERING and 61 31 996 CARRY OUT STEERING ANGLE SENSOR ADJUSTMENT .
Insert locking pins into both rotary and sliding plates
Remove chassis/wheel alignment system