32 00 620 Adjusting Rear Axle
NOTE:
A camber change always means a toe change as well. The camber must therefore be adjusted first.
NOTE:
Vehicles with reversing cameras only:
- Calibrate reversing camera (RFK) after chassis/wheel alignment. See 66 53 010 CALIBRATING REVERSING CAMERA .
Adjusting camber:
Replace nut (2) prior to adjustment and tighten to 5 Nm.
Turn eccentric bolt (1) to adjust camber to setpoint value.
Tighten nut (2).
Tightening torque 33 32 2AZ.
See REAR AXLE - TIGHTENING TORQUES .
Adjusting toe:
Replace nut (2) prior to adjustment and tighten to 5 Nm.
Turn eccentric bolt (1) to adjust toe to specified value.
Tighten nut (2).
Tightening torque 33 32 5AZ.