33 55 021 Replacing Both Rubber Mounts For Stabilizer Mounting

Necessary preliminary tasks: 

• Remove stabilizer from rear axle carrier  . See 33 55 000 REMOVING AND INSTALLING/REPLACING REAR STABILIZER .

Remove retaining bracket (1) and rubber mount (2) from stabilizer.

Installation: 

Coat rubber mount with Circo Light to install retaining bracket.

Fig 1: Identifying Retaining Bracket And Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Keep stabilizer clean and free of oil and grease.

Mount rubber mount (1) by way of slot (2) as pictured on stabilizer.

Fig 2: Identifying Rubber Mount Aligning Slot

Courtesy of BMW OF NORTH AMERICA, INC.