27 10 010 Removing and Installing Transfer Box ATC 700 (Automatic Transmission)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After replacement, the "Repair" service function must be carried out with in the BMW diagnosis system.
WARNING:
Danger to life!
Mount securing fixture for vehicle on lifting platform. See51 71 505 MOUNT SECURING FIXTURE FOR VEHICLE ON LIFTING PLATFORM to prevent the vehicle from slipping off or tilting down.
Mount securing fixture for vehicle on lifting platform. See51 71 505 MOUNT SECURING FIXTURE FOR VEHICLE ON LIFTING PLATFORM to prevent the vehicle from slipping off or tilting down.
IMPORTANT:
After completing work, check gear oil level and top up if necessary.
Filler plug (1):
Tightening torque 27 00 11AZ, see TRANSFER BOX IN GENERAL .
Oil level up to filler edge of filler plug (1).
Use only approved gear oil.
Filler plug (1):
Tightening torque 27 00 11AZ, see TRANSFER BOX IN GENERAL .
Oil level up to filler edge of filler plug (1).
Use only approved gear oil.
Failure to comply with this requirement will result in serious damage to the transfer case!
Necessary preliminary tasks:
- Remove underbody protection. See 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION
- Remove exhaust system bracket from transmission and transfer box
- Remove front and rear heat shields
- Support transmission. See 23 .. UNIVERSAL TRANSMISSION BRACKET
- Remove propeller shaft. See 26 11 000 REMOVING AND INSTALLING PROPELLER SHAFT (INSERTED) COMPLETELY
- Remove front propeller shaft.
- Remove transmission cross-member. See 22 32 050 REPLACING CROSS-MEMBER FOR TRANSMISSION MOUNTING
Disconnect plugs (1) and (2) from servomotor.
Release screw connection of transfer case.
Tightening torque 27 00 9AZ, see TRANSFER BOX IN GENERAL .
Remove transfer case.
Installation:
Pay attention to dowel pin (1).
Grease dowel pin (1).
Apply a thin coat of grease to splines.
Grease: WEICON ANTI-SEIZE.