24 13 012 Replacing output flange shaft seal (GA6HP26Z)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 23 0 490 Puller
- 24 4 310 Mandrel
IMPORTANT:
After completion of work, check transmission fluid level.
See 00 11 500 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (GA6HP26Z)
.
Use only the approved transmission fluid. See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Use only the approved transmission fluid. See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove rear underbody protection. See 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION .
- Remove exhaust system. See 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N52K) .
- Remove heat shields
- Support transmission.
- Remove transfer box. See 27 10 010 REMOVING AND INSTALLING TRANSFER BOX ATC 700 (AUTOMATIC TRANSMISSION) .
Drive a hole into radial shaft seal (1) using a center punch.
IMPORTANT:
Do not use a drill as drillings may result in transmission malfunction.
Screw special tool 23 0 490 into radial shaft seal (1).
Drive out radial shaft seal (1) with impact weight (2).
Installation:
Coat sealing lips of new radial seal with clean transmission oil.
Drive shaft seal firmly home with special tool 24 4 310.