22 32 001 Replacing Rubber Mount For Transmission Mounting

Special Tools Required: 

• 22 1 016 22 1 010 SET OF TOOLS 
• 22 1 017 22 1 010 SET OF TOOLS 
• 22 1 101 22 1 100 FIXTURE 
• 22 1 102 22 1 100 FIXTURE 
• 22 1 103 22 1 100 FIXTURE 
• 33 4 465 33 4 460 SET OF TOOLS 

Necessary preliminary tasks: 

• Remove cross-member. Refer to for transmission mounting 22 32 050 Replacing Cross-Member For Transmission Mounting 

Place special tool 22 1 016. Refer to 22 1 010 SET OF TOOLS on opening (1) and insert screw (2) until hand-tight against housing.

Pull out rubber mount with special tools 22 1 101/ 33 4 465. Refer to 22 1 010 SET OF TOOLS and nut (22 1 017)22 1 010 SET OF TOOLS .

Fig 1: Identifying Rubber Mount With Special Tools (22 1 101, 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Arrow on rubber mount must point to arrow on housing.

Coat housing bore and rubber mount with Circolight, refer to BMW Parts Service.

Fig 2: Identifying Rubber Mount And Housing Bore Center Line

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 22 1 102 with pins into openings of rubber mount. Refer to 22 1 010 SET OF TOOLS

Fig 3: Identifying Special Tool (22 1 102)

Courtesy of BMW OF NORTH AMERICA, INC.

Install rubber mount with special tools 22 1 102/22 1 103/33 4 465 and 22 1 017. Refer to 22 1 010 SET OF TOOLS .

Fig 4: Identifying Rubber Mount With Special Tools (22 1 102, 22 1 103, 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.