11 22 000 Removing And Installing/Replacing Flywheel (N62/N62TU)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 11 4 180
- 11 9 260
- 11 9 262
- 11 9 263
- 11 9 264
Necessary preliminary tasks:
- Remove automatic transmission . See 24 00 023 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA6HP26Z) N62TU .
Automatic transmissions only:
Block flywheel (1) with special tools 11 9 260 /11 9 263 /11 9 264 .
Unfasten flywheel screws.
Remove flywheel (1).
Installation:
Clean threads on flywheel screws in crankshaft.
Flywheel (1) is secured with an alignment pin.
Fit flywheel (1).
Fit new flywheel screws.
Tightening torque 11 22 1AZ . See ENGINE - TIGHTENING TORQUES (N62TU V8) .
Manual transmissions only:
Block flywheel (dual-mass) with special tools 11 9 260 /11 9 262 /11 9 263 .
Release flywheel screws with special tool 11 4 180 .
Installation:
Flywheel (1) is secured with an alignment pin.
IMPORTANT:
Do not use screw locking varnish.
Tightening torque 11 22 1AZ . See ENGINE - TIGHTENING TORQUES (N62TU V8) .