63 31 170 Removing and installing/replacing door handle light on left or right front door

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on HANDLING WIRING HARNESSES and cables.

Necessary preliminary tasks

Remove SOUND INSULATION FROM FRONT DOOR .
Remove COVER ON OUTSIDE HANDLE .

NOTE: Work is shown on the E81 by way of example. There may be differences in detail in the case of other vehicle models.

NOTE: Inner door panel partially shown transparent.

Disconnect plug connection (1).

Release all attachment points of wiring harness (2).

Raise door handle light (4) slightly and remove in outward direction from carrier for outside door handle (3).

Fig 1: Removing Door Handle Light

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure door handle light (1) is correctly positioned in area (2).

Guides (3) of door handle light (1) must be seated in carrier for outside door handle (4).

Fig 2: Identifying Door Handle, Door Handle Light, Wiring Harness And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Wiring harness holders (2) of wiring harness (1) must not be damaged or missing.

Replacement:

If necessary, undo loop (3) to obtain the required cable length.

Fig 3: Identifying Wiring Harness, Wiring Harness Holders And Loop

Courtesy of BMW OF NORTH AMERICA, INC.