51 32 170 Removing and installing/replacing door window glass, front left or right
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove sound insulation in front door, see 51 48 060 Removing and installing/replacing sound insulation in left or right front door .
- Remove inner window cavity cover strip, see 51 21 330 Removing and installing/replacing window cavity cover strip on inner front door .
Open door window glass (1) down to distance (A)
NOTE:
Open door window glass to such an extent that the sliding member of the door window glass holder is at the height of the elongated hole of the power window unit.
A= approx. 120 mm
E71:
A= approx. 80 mm
IMPORTANT:
Risk of injury by trapping!
Disconnect plug connection (1) on power window motor.
Disconnect plug connection (1) on power window motor.
Carefully press catch (2) with screwdriver (3) towards rear and slide door window glass upwards.
Installation:
Catch (2) must be correctly clipped into place.
Carry out function check on power window unit and anti-trapping protection.
If necessary, normalize power window unit, see 67 62 000 REMOVING AND INSTALLING/REPLACING FLAT MOTOR FOR FRONT LEFT OR RIGHT POWER WINDOW UNIT .
Turn door window glass and lift out towards rear/top.
Installation:
Door window glass does not need to be adjusted.