67 62 000 Removing and installing/replacing flat motor for front left or right power window unit

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove sound insulation in front doors , see 51 48 060 REMOVING AND INSTALLING/REPLACING SOUND INSULATION IN LEFT OR RIGHT FRONT DOOR .
Remove front section of power window unit , see 51 33 000 REMOVING AND INSTALLING (REPLACING) POWER WINDOW UNIT IN LEFT OR RIGHT FRONT DOOR .

Release screws (1) and detach flat motor (2) from power window unit.

Installation:

Retaining pins (3) must not be released!

Fig 1: Identifying Flat Motor, Pins And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: To ensure tension-free installation of flat motor, observe the specified screwing sequence without fail.

Tighten first screw (1), then screw (2) and finally screw (3).

Tightening torque 67 62 1AZ , see 67 62 DRIVES, POWER WINDOWS .

Fig 2: Identifying Flat Motor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

A normalization must be carried out in order to activate antitrapping protection.

Normalization sequence:

Ensure adequate system voltage
All doors closed
Press correspond power window switch in "Close" position and hold for approx. 2 seconds with window closed

NOTE: If normalization is unsuccessful or the power window unit malfunctions, it will be necessary to carry out normalization via the control unit functions in the diagnosis system.

Front power window: footwell module
Rear power window: junction box