51 11 141 Removing and installing/replacing bumper panel at bottom front

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT BUMPER PANEL

Version with Park Distance Control:

Disconnect plug connection (1).

Remove cable from holders (2).

Fig 1: Locating Connectors And Cable Holders

G00529513

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Release all catches (1) on left and right.

Remove the bottom bumper panel (2).

Installation note:

Latch mechanisms (1) must not be damaged.

Fig 2: Identifying Bumper Panel And Catches

G00529514

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove BOTTOM MIDDLE GRILLE
Remove UNDERRIDE PROTECTION

Version with Park Distance Control (PDC):

Remove the ultrasonic sensors. See FRONT LEFT SENSOR , FRONT RIGHT SENSOR , and FRONT SENSOR (CENTER) .