37 22... Replacing air supply unit (version with Dynamic Drive)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
Drain the air spring system before carrying out any work on the air supply unit, air pipes and air springs! Danger of injury if this instruction is not complied with!
Risk of damage!
Extreme cleanliness must be ensured in the connection area of the pipes during removal and installation. Even the smallest of dirt particles can cause leakage in the air spring system.
Drain the air spring system before carrying out any work on the air supply unit, air pipes and air springs! Danger of injury if this instruction is not complied with!
Risk of damage!
Extreme cleanliness must be ensured in the connection area of the pipes during removal and installation. Even the smallest of dirt particles can cause leakage in the air spring system.
NOTE:
Read and comply with NOTES ON AIR SPRING SYSTEM .
Necessary preliminary tasks:
- Deactivate and empty AIR SPRING SYSTEM
- Remove RIGHT UNDERBODY PANELLING
- Remove RIGHT TANK UNDERRIDE PROTECTION
Release screw pins (1) and open holder.
Installation note:
Replace screw pins.
Tightening torque 37 14 22AZ .
Expose control lines (1) up to front tension strut.
Remove connecting line for valve block from holder (3).
Release nuts (2) and remove valve block from body.
Installation note:
Replace self-locking nuts.
Tightening torque 37 14 10AZ .
Further procedure is identical to:
- Replacing AIR SUPPLY UNIT
After installation:
- Activate and fill AIR SUSPENSION SYSTEM