27 10 010 Removing and installing transfer box ATC 700 (automatic transmission)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After replacement, the "Repair" service function must be carried out with in the BMW diagnosis system.
WARNING:
Danger to life!
Mount securing fixture for vehicle on lifting platform to prevent the vehicle from slipping off or tilting down.
Mount securing fixture for vehicle on lifting platform to prevent the vehicle from slipping off or tilting down.
IMPORTANT:
After completing work, check oil level and top up if necessary.
Filler plug (1):
Tightening torque 27 00 11AZ , see 27 00 TRANSFER BOX IN GENERAL
Oil level up to filler edge of filler plug (1).
Use only approved oil. See TRANSFER CASE - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Necessary preliminary tasks:
- Remove UNDERBODY PROTECTION .
- Remove exhaust system bracket from transmission and transfer box
- Remove PROPELLER SHAFT .
- Remove FRONT PROPELLER SHAFT .
- Support transmission.
- Remove TRANSMISSION CROSS-MEMBER .
Disconnect plugs (1) and (2) from servomotor.
Release screw connection of transfer case.
Tightening torque 27 00 9AZ , see 27 00 TRANSFER BOX IN GENERAL
Remove transfer case.
Installation:
Pay attention to dowel pin (1).
Grease dowel pin (1).
Apply a thin coat of grease to splines.
Grease: WEICON ANTI-SEIZE.