24 00 054 Installing exchange transmission (GA8HP45Z) (X6 35i 2011-13)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.
Drain automatic transmission fluid at oil drain plug.
Tightening torque 24 11 2AZ .
IMPORTANT:
After completion of repair work, program control transmission control unit.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations.
IMPORTANT:
- Before installing replacement transmission, always flush TRANSMISSION FLUID COOLER TOGETHER WITH LINES .
- After completion of repair work, check TRANSMISSION OIL LEVEL .
- Use only the approved transmission oil:
ATF oil Shell L12108* .............. BMW part number 83 22 2 152 426
* Can be substituted by the lifetime oil "ATF -3".............. BMW part number 83 22 2 305 397
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove AUTOMATIC TRANSMISSION .
- Remove and modify TRANSFER BOX
Modify transportation retainers.
Convert all cable clips.
Convert all seal plugs.
Convert protective cap on output shaft.
IMPORTANT:
After removing transportation retainer, secure torque converter against slipping out.
Transmission identification:
- refer to BMW Parts Department.
- On type plate