33 32 681 Replacing one rubber mount in lower control arm (control arm removed)

WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 3 35133 3 350 SET OF TOOLS
33 3 35233 3 350 SET OF TOOLS
33 3 35333 3 350 SET OF TOOLS
33 3 35433 3 350 SET OF TOOLS

Attach special tool 33 3 354 between both control arms.

Press rubber mount with special tools 33 3 351 and 33 3 352 out of lower control arm.

Fig 1: Special Tool (33 3 352), (33 3 354) And (33 3 351)

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 33 3 354 between both control arms.

Press in new rubber mount (1) with special tools 33 3 351 and 33 3 353 .

Fig 2: Special Tool (33 3 354) And (33 3 351)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION