22 32 001 Replacing rubber mount for transmission mounting

WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

See 22 1 010 SET OF TOOLS .

22 1 011
22 1 014
22 1 016
22 1 021
33 3 144

Necessary preliminary tasks:

Remove complete exhaust system, see 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM
Remove heat shield
Support transmission with hydraulic lifter.
Remove transfer case, see 27 10 010 REMOVING AND INSTALLING TRANSFER CASE (ATC 400 X-DRIVE) .

Position special tool 22 1 016 on opening (2) and twist in screw (3) hand-tight against housing.

Pull out rubber mount with special tools 22 1 011 / 33 3 144 and nut (1).

Nut (1) = M 12x1.5 nut

Fig 1: Pulling Out Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Arrow on rubber mount must point to arrow on housing.

Coat housing bore and rubber mount with Circolight.

Fig 2: Arrow On Rubber Mount And Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 22 1 014 with pins into openings of rubber mount.

Fig 3: Special Tool 22 1 014

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount with special tools 22 1 014 / 22 1 021 / 33 3 144 and nut (1).

Nut (1) = M12x1.5

Fig 4: Installing Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.